Search results

Hi, (for the Ruckus) you need 4x4 Traxxas axles. These are 2wd, i understood they are shorter and know the 4x4's fit with a small mod.

Yep, the Ruckus is really cheap in comparisson to its competitors so even with 50 euro axles it is still cheap. You can try the cheaper plastic Traxxas axles from the slash 4x4. I've read that they hold up better than the stock ECX ones but have no experience with them.

Hi Matze, same price here in the Netherlands. I do agree it's expensive but the options are very limited for the Ruckus (without mods) and i haven't seen cheaper and good performing options. With mods to Traxxas axles it's still expensive. The MIP's i just ordered cost €65,-. And the Integy's...

I would say for 2s and mod free installation with no binding get the Hotracing SECT288X06. And keep 'm lubricated for minimal wear with a very little bit of thick grease.

Just to test if it is possible to swap left and right. Should work with the RPM arms but the design of the stock ones is more suitable for new shock mounting holes. The MIP's are in backorder.

Hi Matze, it all depends on the power. What battery type do you use?

Next update: swapped the rear a arms and moved the shocks to the back of the shock tower. The angle in the cvd's is gone and no binding. Lets go for a test drive....o_O

It's 2WD

Yep, and no warranty..i double checked everything but it's not the right product for the Ruckus. I still won't give up on it though. The big difference between a Slash is the angle of the axles from the diff to the hub. It's quite large and puts a lot of stress on the cvd's so i just swapped the...

So i loosend the slipper clutch, drove for 10 minutes and this is what happened to the Integy shafts.......:mad::mad::mad:

Yes it came stock with yhe 24t pinion. It's the 2wd brushless version with the not 3s capable esc. The speed is good with the 20t pinion. I have upgraded everything, guess only the chassis is standard :D Now the only thing we need are some good axles...

Hi Chuck, thanks for your input! I am running a Hobbywing Max10 60a with a 3300Kv motor on 3s, the slipperclutch is half a turn loose from full lock, punch setting is set on medium (standard setting) and i installed a smaller pinion 20t (comes standard with 24t) with a Hotracing steel spur 87t...

Let's hope you have better luck with them! https://www.integy.com/st_prod.html?p_prodid=29509&p_catid=268&ratesortby=New#.Wo7M8NDvJnE And let's hope these will hold...

For everybody reading this post and considering hot racing products: SECT288 after 8 3s packs The cups and dogbones bind and the cups will start to wobble because of that putting a lot of stress on the diffs. The joints wear very fast. SECT288X06 The blue aluminium pin holder is too...

Try this one:

I do think the Ruckus brushless is overgeared for 3s. I went down to 22t, it really made it come alive!