ECX13010 V4, control the speed and steering offline through some on-board circuit. Is this possible ?

cyndwith

New Member
Messages
2
I have ECX13010 V4, I want to hack it and control speed and steering through on-board circuit. Is this possible ?
Any reference or details would be appreciated.

PS: I see some pins (GND, CH2, CH3) on the receiver (highlighted in the attachement). What do they do ?
 

Attachments

loosenut

Active Member
Messages
37
Take internals out of transmitter, disconnect physical inputs, replace with the device you have created that creates electric inputs, bolt onto chassis.

Now you have an on board controller?
 

cyndwith

New Member
Messages
2
I was planning on programming a Raspberry PI to do that. Will that be a problem ?

Any useful references to the control signal generation or User Manual / Data Sheet for ECX13010 ?
 

loosenut

Active Member
Messages
37
Your transmitter probably has:
Physical Control > potentiometer > radio

My suggestion is change it to:
RaspberryPi > digital potentiometer > radio

That way you don't need to build anything specific to any particular receiver.
 
Top