Torment drive axles 2wd

Egoaudio

New Member
Messages
1
Hello everyone,

Back in rc from about 20 years ago. Picked up a pair of used 2wd torments with brushless systems and need to replace a pair of drive shafts.

Anyone know if these Would these work? Looking for something inexpensive but more robust than factory plastic shafts, if possible.

If these won't work any other economical recommendations?

Thanks!

http://www.activepowersports.com/in...Z9EvKPVm9XFAuC-KL-cZpmHaWeoNIkJsaAlJNEALw_wcB
 
Last edited:
Yes those will work. The only small mod(s) needed is the stock exc hex would need to be drilled out on the smaller side (outside), or a set of new traxxas(or most brands) aluminum hexes should be used. Some traxxas driveshafts also need the transmission side drilled a little deeper. I know the plastic traxxas stock ones need it, but I got a set of steel ones that didn't. Not sure on the integy ones. There is a thread in the rukus section, which I believe has the same shafts you are looking at in, that discusses several types of driveshafts. It's the same driveshaft as the torment.
https://www.ecxforum.com/threads/which-driveshafts-for-ecx-ruckus.284/
 

Latest posts

Members online

No members online now.
Back
Top