I purchased a Torment for My son at Christmas 2016, this is the first RC truck we have owned so we are noobs. I found the recall for the ESC and I received a new one, I think is 60A. Now the truck won't run off the original 1800mah lipo battery. It will run for about a min then it goes into slow mode. If I shut the ESC off then back on it rill run again for a min and do the same thing. It seems to work using my 5000mah 30C ok. Is there anyway to fix this ESC settings? It is set for lipo battery right now. The new ESC came to me and it was set up to run with no reverse. I had to take the jumper out to get reverse. Or I could use "crawl" jumper setting but either setting didn't work to run the 1800 battery. I thought this new ESC was going to fix a problem not create a new one any ideas?
Secondly the new ESC seems to operate differently than the original 40A. The original seemd to have full power until the last 15-30 seconds of run then it would go dead. The new one will go into slow mode (using the 5000mah 30c lipo 2S) where it will run that way for a few minutes before going dead. Is that how it is susposed to run?
Secondly the new ESC seems to operate differently than the original 40A. The original seemd to have full power until the last 15-30 seconds of run then it would go dead. The new one will go into slow mode (using the 5000mah 30c lipo 2S) where it will run that way for a few minutes before going dead. Is that how it is susposed to run?