Looking for someone to CNC hexes
- Thread starter Ruckus7B
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Reached out to them this morning. He doesn’t have a way to cute hexes.
WithinU
Well-Known Member
- Messages
- 519
- Location
- Land of Oz
Is this something totally custom or could you get close and have someone modify them to fit your needs?
Like is there a set that only needs the ID enlarged?
Like is there a set that only needs the ID enlarged?
There isn’t. All 14mm hexes are 6mm bore for axle with a 2.5mm cross pin. These would be totally custom to run on my ruckus.
What about swapping to a 6mm axle with a 2.5 cross pin? If you're going to spend the money, at least you have the upgraded drivetrain to boot.
I’m all for that if I can find one with the right specs.
the xo-1 rear hubs can be made to work with RPM Ruckus arms which should allow you to run the xo-1 6mm rear axles. tekno makes a 6mm kit which comes with hubs for a slash 2wd, not quite sure if that would work being that it's a fixed dogbone.
as far as the front goes, I don't know, but I've seen quite a few front hub swaps on here and on the FB group
