Rpm bell crank-has anyone installed this????

[mrc82]

I purchased the rpm servo eliminator and the bearings to replace the bushings. I was wondering if the circuit or amp guys have done this swap and which servo saver I should use

 

[rob5059]

I installed on on my Boost, and did not install a servo saver.

 

[mrc82]

Nice, are you a basher or racer? I bash the crap out of my amp like everyday. But I read where if you keep the plastic turnbuckle they become the week point and king of act like a servo saver. I also ordered an all metal gear servo

 

[rob5059]

I am a basher. Once the stock servo breaks, I will put in a Hitec 7955 servo. I have been running my Slash like this for about a year with no problems.

 

[i_r_beej]

@mrc82 I've got the RPM bellcrank and a metal-geared servo. Just use the plastic servo horn and you'll be fine. The stock plastic steering links may also pop off in the event of a high-energy impact.

 

[fuzzy420]

mine just broke the top plate in a high speed impact but no damage to steering linkage