RPM replacement bell crank for 2WD Torment

[MikeG]

Hi guys,

I purchased the RPM bell crank to upgrade the stock bell crank that comes with the Torment. My problem is I bought this last fall and started it but never finished it, now I have it all ready to go and I'm missing some hardware. I was hoping someone could help me out with what parts I need to buy to get this new bell crank attached to the body.

I have the new bell crank assembled and partially attached but I can't find the screw to attach the second part to the body (see image below)

Can anyone help with what hardware I'm missing to get this attached? I'm assuming its something that came with the original truck so if I could get a part number or any help would be much appreciated.

 

[Whoanelly]

That part is your idler arm, it bolts on through your skid plate into your chassis.I will post a picture of mine.

 

[Whoanelly]

My setup is hot racing ( I like the servo saver) but it goes on the same way.

 

[MikeG]

My setup is hot racing ( I like the servo saver) but it goes on the same way.

Thanks for the pic! that definitely helps, since I'm missing the hardware do you think its the ECX1044 Hinge Pin Set that I need?

 

[Whoanelly]

No it's just a long bolt and nut, it passes through the skid plate into your bellcrank and into your chassis

 

[Whoanelly]

I'll look up the part for you later today for I am at work.

 

[Whoanelly]

Yo the part is a m3x25

 

[Whoanelly]

I think you have to order the ecx screw set, there's no individual part number.

 

[MikeG]

I think you have to order the ecx screw set, there's no individual part number.

ok I see that in the exploded view, I'll look for that screw set. Thanks for your help!

 

[Whoanelly]

ok I see that in the exploded view, I'll look for that screw set. Thanks for your help!

All you really need is a m3x25 mm and a nut. These hold the original skid plate on also.