Ecx temper driveshafts

CumminsFan

Well-Known Member
Messages
72
After i put a brushless motor in my temper it almost immediately snapped the front driveshaft. I found some short metal driveshafts on ebay, but only one side fits. Is there any driveshafts that fit without modifications? Or can i use barrage outdrives? The barrage outdrives look to be longer. I don't know if i can modify the transmission case because i havent opened it up yet, but i can modify the motor plate. Will i just have to modify this driveshaft? Or just use my old one off the back and hope it doesn't break?

20190724_145258.jpg20190724_145337.jpg
 
so after posting my thread about the gen2 I found out the gen1 and 2 are the same driveshafts. can you get the bottom picture to hold or is the set screw hole past the shaft?
 

Latest posts

Members online

Back
Top