Ecx temper driveshafts

CumminsFan

Well-Known Member
Messages
72
After i put a brushless motor in my temper it almost immediately snapped the front driveshaft. I found some short metal driveshafts on ebay, but only one side fits. Is there any driveshafts that fit without modifications? Or can i use barrage outdrives? The barrage outdrives look to be longer. I don't know if i can modify the transmission case because i havent opened it up yet, but i can modify the motor plate. Will i just have to modify this driveshaft? Or just use my old one off the back and hope it doesn't break?

20190724_145258.jpg20190724_145337.jpg
 
so after posting my thread about the gen2 I found out the gen1 and 2 are the same driveshafts. can you get the bottom picture to hold or is the set screw hole past the shaft?
 

Latest posts

Members online

No members online now.
Back
Top