Bigpoppa99
Well-Known Member
- Messages
- 99
Considering ordering two of these trucks (AMP MT) in kits for me and my son to put together and bash around. I have a few questions, and some I have read about here on the forums but just don't quite understand.
Tires: I understand the stock tires don't have foams and make poor handling of the truck. Any recommendations for tires/wheels of the same size as stock? I mostly plan to run on dirt, grass, and occasional SC track (packed dirt), occasional pavement.
Servo: By reading I can tell the stock servo is out of the question, so I plan to put in the Power HD 1501 at the time of build.
Servo Saver: A bit confused here. On weather to try it stock or go ahead with the RPM eliminator. I read where some like it, then I seen a review where a guy said he put one on and went back to stock servo saver.
Bumpers: I kept seeing Tbone bumpers mentioned, can you guys link me to the Tbone bumpers for the AMP MT you are referring to?
Power HD 1501, will that servo run fine by plugging in like the stock, or can it handle the volts from a 2s lipo? In my r/c crawlers I have my high torque servos wired straight to my 2s lipo.
Bearings: I read the stock bearings are not too good, so I may go with Fast Eddy bearing from the time of build.
Tires: I understand the stock tires don't have foams and make poor handling of the truck. Any recommendations for tires/wheels of the same size as stock? I mostly plan to run on dirt, grass, and occasional SC track (packed dirt), occasional pavement.
Servo: By reading I can tell the stock servo is out of the question, so I plan to put in the Power HD 1501 at the time of build.
Servo Saver: A bit confused here. On weather to try it stock or go ahead with the RPM eliminator. I read where some like it, then I seen a review where a guy said he put one on and went back to stock servo saver.
Bumpers: I kept seeing Tbone bumpers mentioned, can you guys link me to the Tbone bumpers for the AMP MT you are referring to?
Power HD 1501, will that servo run fine by plugging in like the stock, or can it handle the volts from a 2s lipo? In my r/c crawlers I have my high torque servos wired straight to my 2s lipo.
Bearings: I read the stock bearings are not too good, so I may go with Fast Eddy bearing from the time of build.