motor

Is it necessary to water break in your motor? How beneficial is it to break it in that way?

My son took his Ruckus out over the weekend and not even a good 10 minutes into him playing with it, the truck died. He wasn't even driven it hard either. I always charge our batteries up before we go out to drive our trucks so I knew the battery wasn't dead. When I squeezed the trigger, the...

Is there a good replacement motor for ECX AMP? carson cupmachine for example or what options do i have? for now i am not going for brushless.... so what brushed motor would be the best option?

I'm under the impression that my Amp's 20T motor is losing power. It does get quite hot (2 second finger test failure hot) as I run it on the grass non-stop typically. So, if I were to get a brushless motor, where would a 17.5T put me? And a 13.5T? Both would be Turnigy Trackstar sensored (my 4...

The only question I have for y’all is about motor behavior: does yours make that kinda shhhh-shhhh-shhhh-shhhh-shhhh-shhhh noise while moving forward? Very hard to describe it with words, but almost sounds like a stuttering. It runs fine, but the sound is definitely not smooth when compared to...

So I have seen some posts about monitoring the motor temp, especially if you run in the grass. Question is, for my brushless 2WD, should I be monitoring the motor temp or is that a brushed motor thing?

Hey all, It is time.....time to upgrade the torment to a brushless system. So using the expierience of you wise men and women I thought to ask you all what is the best setup(in your opinion) for the ecx torment. I bash 99.99% of the time to torque is what im looking for but with a good amout of...

Which motor is best. 12t or 20t.

Hey @Aiden you've mentioned that you installed the HPI Firebolt 15T brushed motor in your Boost. I'm going to assume that you've not had any issues with the ESC overheating or otherwise suffering the additional load of the 15T motor?

Looking to do a brushless upgrade in my 1/18 scale ruckus. I have never done this before. But i want to be able to run faster and longer than stock. What can you guys recommend for a good brushless motor and whatever else i may need with it.

Just ordered a tazor 280 for the rc. Was wondering who's had experience with this motor? What's the gains and what is the install like?