Steering servo for a 4x4

[Batone76]

Start with one full turn off. If that is too much still go in 1/4 turn increments.

Anything particular i should be looking for or sound to know if its good position

 

[sc302]

Start with one full turn off. If that is too much still go in 1/4 turn increments.

Anything particular i should be looking for or sound to know if its good position

Prob should watch the ecx video on how to adjust your slipper clutch.

 

[nate94gt]

I use this servo for my axial bomber. It's strong and fast enough. I also have a Bec installed and set to 6v just because. It's a power HD 1501mg
http://m.ebay.com/itm/Power-HD-1501...%3A36bd3b331580a5e295e88d7ffff68869%7Ciid%3A1

 

[Jp1ruckus]

Like I said I can make it flip over if I cut the wheel hard at full speed (without the brake turn). So increasing turning speed or angle will only pronounce that issue more. But then again I am on a stock brushless ruckus with 2s 30c lipo. I am not sure which setup you have in your 4wd torment.

 

[Jp1ruckus]

Hello mate. Have you had any problems with your brushless ruckus.