ruckus

I have a couple questions that should have easy answers, but I can't find them on here: T-Bone front bumper: So I just installed one of the T-Bone front bumpers for my 2wd ECX03014. First, I uninstalled the existing bumper, installed this one, easy. BUT - after the first run, I noticed...

Hi all. I'm looking for some advice on setting up my (OK, my daughter's) 2WD Ruckus to wheelie. I've read some posts and tried some things, but no luck yet. I've tried a 16T and a 15T pinion and I've tried tightening the slipper clutch; I'm running 2S lipo (it's the model that comes with one...

I just got a practically brand new brushed 2wd Ruckus for $80 of ebay. The steering on this thing leaves a lot to be desired. Is the servo saver eliminator worth it to improve steering? I have a couple of 18kg mg servos sitting around and will probably throw one of those in too. I do not have...

I have a ecx ruckus 1/10 , I sold the remote and receiver several months back. But I was able to fix my ruckus, and I need a remote and receiver.My question is, if axial crawler remote and receiver will work on my ruckus?

I have a stock 4wd 1/10 ruckus the esc has a nickel and lipo setting I hooked up a 3s 2200 lipo to it and I have no throttle please help so my boys can play stresses dad here

Just found these, wondering how they would work on my 2wd ruckus... https://www.prolineracing.com/tires/badlands-mx28-2-8-traxxas-style-bead-all-terrain-tires-mounted-front-f-11-stone-gray/ specs seem little more similar to stock tires compared to trenchers but those treads.... wondering if...

I turn on my ruckus and no beep. I have steering no throttle.

Hi all, I have owned my 4x4 Ruckus for a couple years and I really want to upgrade it. I have replaced the front and rear bumper with T-Bone Racing, and just replaced a worn out Spur gear. Now I lost a front driveshaft, so I need a replacement. I think Hot Racing is what I will go with...

Did some upgrades to the sons Ruckus Here is the result :)

I think I have replaced the motor in my son's Ruckus about 4-5 times now since I bought it and I think its time to go brushless. I am still new to the whole RC world so I need some suggestions on a good brushless motor set up. My son is 6 and can handle the Ruckus most of the time. If the...

Has anybody put diff oil in a standard diff? I just pull my diff apart and noticed there are no seals in there... I was going to put 10000wt in it.

I see all the different drive shafts on the internet but most are for 2wd. What can I use for the front other than stock?

All, recently bought an 1/18 Ruckus. On day 3, the right rear wheel was not spinning. After a full break down, found that one of the gears in the rear transmission had a double-d slot which had stripped out and was causing the screw to back off under any torque conditions. This effectively...

On our new Ruckus 1/10 the steering servo is turning 75% either way, and then pausing before finishing the full turn. There doesn't appear to be anything blocking the steering arm. I have also tried adjusting the trim and the gain from the control to no effect. Any ideas? I am assuming the...

I've been taking pictures of all my RC's, and I wanted to show you my solution for not breaking/scratching your rear bumper when you're a little "wheelie happy" It's a furniture wheel, fitted with a pair of M3 hex screws, washers and locknuts. There's an aluminum plate with the same...

I know this isn't going to win me any popularity points but can I put a smaller batter in a 1:18 Ruckus? If so can someone please point me in the right direction? I would like to do this because I purchased this for my 4yr boys and need to tone it down. Thank you!

I've broken several front driveshafts and front axles on my 1/10 4x4 Ruckus. Running stock motor with (non 3S restricted) Dynamite Tazer 45A ESC with 3S and stock tires. What brand driveshafts are you using? Which ones are the most durable? For installation, please explain any mods that may...

Hi all. I am looking to aquire myself a Ruckus, but have trouble finding a dealer. I live in Europe, Denmark to be specific. Anyone who knows how I can find a dealer? Hope you can help me!

the servo in my ruckus 4wd only free wheels there is no gear sound or gear feel when moved left to right. Is this a sign that it is time to get a new servo or is it something inside the servo that I broke?

Hello all , I have ordered 2 rc cars the 2wd and 4wd ruckus both brushless too. I am wanting to know if they use the same parts like the same shock towers , same bumpers , same bolts ( hardware ) same castors, hub knuckles. I haven't got my cars yet and wanting to upgrade to some steel...