esc

So I think the ESC on my son's AMP MT has gone out again, this would be the second one now and I think I will just upgrade it. The truck will steer and go forward fine, but has lost it's reverse. Couldn't find anything in the manual about a race mode, and I tried adjusting the throttle trim...

Hi, I want to go for a brushless setup in my ecx circuit 2wd. I was planning on going with a goolrc setup. My question is wat combo should I buy for my rc? I probably could find it out myself. But it would be a lot faster to just just ask on the forum :D.

I have the 4x4 torment (grey body) and recently upgraded to brushless. Now it spins out at 3/4 throttle. Wondering how to solve that issue. Everything else is stock btw

so I have the castle combo 5700kv with the sidewinder3 esc.....the esc gets to hot after 5 min run time using a 20c 2s dynamite lipo. so the original on/off switch fried so I took the switch from the stock esc for the ecx amp and wired that switch to the esc...does anyone think that might be why...

I am very pleased with the fit and performance of this Hobbywing WP10BL50/3300kv combo. It was $44 shipped. https://www.aliexpress.com/item/50A-Waterproof-ESC-HSP-37017-03307-Brushless-Engine-Motor-540-3300KV-03302-Support-2S-3S-Lipo/32749658055.html?spm=a2g0s.9042311.0.0.ZfQPQx

Ordered the new radio,esc and servo for my amp kit. Radio is a Tactic ttx300 3 channel. I like these they are decent but not overly complicated and pretty rugged have one on my sawback and it works great. The 3rd channel can be made 2 3 or 4 position. Also its a small rx and no antenna wire...

My torment was running fine I removed the speed control and receiver to trouble shoot with another car I have. After I reinstalled to the original car now my Torment will not respond I can not find the instructions on how to bind the receiver and the controller does anyone know where I can find...

Hello, I got a couple of AMP's, one had the speed controler go out. I called Horizon Hobbies and they sent me a new one (for free!), however it is the upgraded one that can take lipos. So I attached it, took me forever to bind it, and now it will only steer the front wheels. I can't go...

I think I have replaced the motor in my son's Ruckus about 4-5 times now since I bought it and I think its time to go brushless. I am still new to the whole RC world so I need some suggestions on a good brushless motor set up. My son is 6 and can handle the Ruckus most of the time. If the...

So I just ordered these off horizon and wanted to know what every one thinks? Also ordered the wrong battery for the connection type any ideas? Or will I need a different one? https://www.horizonhobby.com/sv3-waterproof-esc-1406-5700-sensored--010011506-cse010011506

Hello All, I bought an ECX amp MT for my son and he loves it. Together, This is our first hobby grade R/C car. We have been learning a lot and changing things out as we go but there is one thing i cannot find an answer to in the internet: We are running a Dynamite 60a ESC (DYNS2210) with a...

Hello, just seeing if anyone would know the answer to this question. Would a hobbystar 35a esc/120a burst be sufficient in the boost with the skyrc toro 2800kv motor? That motor claims the "max current" to be only 33a, this kind of confused me as its a 540 motor and I've even seen cheaper ones...

Hello to all, I have a ECX Boost running a Castle Creations Sidewinder 3 w/ a 5700kV brushless motor. I’m experiencing very bad overheating issues. I can no longer go full throttle without the power cutting in and out. Then the ESC cuts power completely and the only thing that works is steering...

Hi there ECX fans, Will the stock ESC from the Barrage kit (5V BEC) handle a high torque servo okay? Please let me know if you have any direct experience with this issue. Thanks! -MP

Do you have to change the speed sensor if you go with a brushless system like the Tazer Two by Dynamite.

Hello guys! I bought a Ruckus 4WD with 3300kv motor and the tazer dynamite dyns2400. This things can work with a 3S lipo? thanks :)

Can I pretty much run any 60A to 70A brushless esc with my stock tazer 3300kv brushless motor? Looking to upgrade to a better quality over my Tazer 45A ESC.

Turned on my Ruckus and ESC fan went up in flames. Those cheap little fans suck Smells really bad now after have to clean it up or maybe use as parts tuck and get new one.

I have a 1:10 4wd ruckus that I haven't run in a while. The battery pack reads 8v so I believe it is charged I think is a 7.2v. I put new batteries in the controller. When I turn it on, it starts up correctly but it will not go. If I lift it off the ground, I can get the wheels to run. I also...

I have noticed that the kinexsis motor and esc combo is becoming more noticeable in the forums. I have had mine for about a year now and I like it alot. If you have any comments about the system, chargers and batteries, leave some comments. Thanks! I was thinking about getting the kx80 80w...